Doug Fleenor DMX512 to 0-10 Volt Analog Converter - 96 Channels

Zero to ten volt analog control still has a place in the modern lighting control world. Interfacing to older dimmers, custom controls, animatronics and motion control are just a few of the uses of our DMX512 to 0-10 Volt Analog Converter.

Specifications:

• Input baud rate: DMX512: 250 Kb/s, CMX: 152.6 Kb/s
• Input circuit: EIA-485 receiver with series 100 ohm PTC self resetting "fuses" clamped to +/- 7 volts by four low capacitance transorb diodes

Input signal:

• 0.5 volts minimum, 12 volts maximum
• Input can withstand up to 120 volts without damage, transients up to 5KV
• Output circuit: LM324 quad op amp with 1N4004 series diode

Output signal:

• 0 to 10.1 volts positive DC into 2000 ohm load
• Outputs can withstand up to positive 400 volts without damage
• Outputs cannot withstand high negative voltages
• Max. output current: 15 mA per output, 120 mA total all outputs (360 mA total on 96 out version)
• Input/output isolation: Greater than 500 volts
• Throughput delay: Less than .005 seconds (DMX input change to analog output change)
• DMX512 connectors: Two gold plated 5 pin Neutrik D-1 Series (male input, female pass through) (All five pins are wired on the pass through)

Analog connector:

• Female DB-25 with gold plated pins
• Pin number equals output number, pin 25 is output common

Power input

•  90 - 125 volts, 50/60 hertz, 10 watts (180 - 250 volts optional)

Color

• Silver anodized aluminum

Size and weigh

• 8.0" deep, 1.7" high, 16.7" wide, 4.5 pounds (19" adapter available)