Pathway eDIN 12 Channel Contact Closure Interface
Pathway eDIN Contact Closure interface provides 12 DMX-controlled dry contact closures for both power and signal level switching.
Multiple operating modes include momentary, maintained, 6-channel split and single channel select, where the DMX level of the start channel determines which relay is active.
- 12 DMX controllable form-C switch closures
- Momentary or maintained operation
- 'DMX Present’ relay function
- DMX level display
- 6-channel alternate mode
- DMX-select mode, where DMX level corresponds to a triggered relay
- DMX start address easily set
- LED display and push buttons for configuration
- 2500V DMX input opto isolation
- 250V DMX fault protection
- End-of-line termination switch
- Status LED's for power, DMX input, relay state
- Pluggable screw terminals for all connections
- DMX pass-thru connector
- Snap-on DIN rail housing
- DIN rail mounting section included
- Relay Contact Rating: 2A per relay, at up to 30VDC
- Power Supply: 9-30 VDC, 5W supply required. Use eDIN 1001 power supply or equal.
- Isolation: 2500V opto isolation, 250V fault protection
- Size: 3.5" x 8" x 1.25" (90mm x 200mm x 30mm )
- Mounting: 35mm x 7.5mm DIN rail (included)