Clear-Com 4 Ch CC I-Com + 2 Video in 6 Video out Fiber MUX
Details
Clear-Com 4 Ch CC I-Com + 2 Video in 6 Video out Fiber MUX
A 1RU single point to point BroaMan Intercom and Video interface with two SANE CAT5 network ports and Optocore Single-Mode LC Fiber interface, includes 4 Clear-Com RS422 intercom channels, 2 3G-SDI video inputs and 6 3G-SDI video outputs and GPIO Option card. A separate sync i/o, 2 LAN ports and 1 Auxiliary 1310nm fiber tunnel are available. Redundant PSUs included.
NOTE at least two compatible BroaMan MUX-22 interfaces are required for an end to end link.
Features:
- 1RU 8-Port Fiber Transport Interface Devices
- Seamlessly transports, routes and distributes audio, video, intercom and control data over one fiber optic cable
- Full integration into SANE, DiViNe and Optocore network
- SD/HD/3G-SDI capacity
- 8 SD/HD/3G-SDI ports
- 4 simplex LC fiber ports
- CWDM (Coarse Wavelength Division Multiplexing) module
- Tri/Bi-level video clock input and output module
- Optocore module
- 2 x Optocore 2Gbps ports
- 2 x SANE/LAN ports
- 2 x LAN ports
- 4 x RS485/422 ports
- Word Clock I/O
- Redundant power supplies
- Full control with ProGrid control software
- LAN, USB and RS232 ports for configuration
Specifications:
Intercom Ports
- Connector: 4-wire Clear-Com standard; 4 x input, 4 x output RJ45, Clear-Com convention
Optical Link
- Connection: Duplex LC
- Protocol: Optocore
- Transmission: Full Duplex
- Fiber Cable Lengths: Standard singlemode transceiver <10 km; Special singlemode transceiver < 80 km (on request)
- SANE, LAN ports
- Auxiliary Ports
- Convention EIA / TIA-485
- Data channels: Digital control data; 4
- Data rate: Up to 10 Mbps
- Impedance: Termination; 330 Ω; Source; ≤ 10 Ω
Video
- Standards: SD, ED, HD, Dual Link, 3G
- Complies with SMPTE: 259M, 292M, 344M, 372M, 424M
- Interface: SDI – Serial Digital Interface
Word Clock
- Hardware standard
- BNC – 75 Ω
- Data Rate: Dependent on sample rate; Up to 192 kHz
- Impedance: Output ≤ 5 Ω; Input 75 Ω
- Drive Level: Output; ≥ 1 Vpp
- Zero Level: Referring to GND; +1.7 V
- Sense Level: Input; ≥ 400 mVpp
Optical Connection
- Complies with 21 CFR 1040.10 and 1040.11
Remote Control
- RS232: EIA / TIA – 232; 57 600 Baud
- USB: USB 2.0 – Device; 12 Mbit/s
- LAN: IEEE – 802.3; 10/100 Mbit/s
Power Supply
- Type: Switch-mode, universal input
- Main Voltage: 100-240 V; 50-60 Hz
- Frequency: 50-60 Hz
- Cooling: Passive, via surface and ventilation openings on both sides of the device
MUX22_BroaMan_Manual