Clear-Com 4 Ch RTS I-com + 8 video out Fiber MUX

A 1RU single point to point BroaMan Intercom and Video interface with two SANE CAT5 network ports and Optocore Single-Mode LC Fiber interface, includes 4 RTS RS485 intercom channels, 8 3G-SDI video outputs and GPIO Option card. A separate sync i/o, 2 LAN ports and 1 Auxiliary 1310nm fiber tunnel are available. Redundant PSUs included.

NOTE at least two compatible BroaMan MUX-22 interfaces are required for an end to end link.

Features:

• 1RU 8-Port Fiber Transport Interface Devices
• Seamlessly transports, routes and distributes audio, video, intercom and control data over one fiber optic cable
• Full integration into SANE, DiViNe and Optocore network
• SD/HD/3G-SDI capacity
• 8 SD/HD/3G-SDI ports
• 4 simplex LC fiber ports
• CWDM (Coarse Wavelength Division Multiplexing) module
• Tri/Bi-level video clock input and output module
• Optocore module
• 2 x Optocore 2Gbps ports
• 2 x SANE/LAN ports
• 2 x LAN ports
• 4 x RS485/422 ports
• Word Clock I/O
• Redundant power supplies
• Full control with ProGrid control software
• LAN, USB and RS232 ports for configuration

Specifications:

• Intercom Ports
  • Connector: 4-wire Clear-Com standard; 4 x input, 4 x output RJ45, Clear-Com convention
• Optical Link
  • Connection: Duplex LC
  • Protocol: Optocore
  • Transmission: Full Duplex
  • Fiber Cable Lengths: Standard singlemode transceiver <10 km; Special singlemode transceiver < 80 km (on request)
  • SANE, LAN ports
  • Auxiliary Ports
  • Convention EIA / TIA-485
  • Data channels: Digital control data; 4
  • Data rate: Up to 10 Mbps
  • Impedance: Termination; 330 Ω; Source; ≤ 10 Ω
• Video
  • Standards: SD, ED, HD, Dual Link, 3G
  • Complies with SMPTE: 259M, 292M, 344M, 372M, 424M
  • Interface: SDI – Serial Digital Interface
• Word Clock
  • Hardware standard
  • BNC – 75 Ω
  • Data Rate: Dependent on sample rate; Up to 192 kHz
  • Impedance: Output ≤ 5 Ω; Input 75 Ω
  • Drive Level: Output; ≥ 1 Vpp
  • Zero Level: Referring to GND; +1.7 V
  • Sense Level: Input; ≥ 400 mVpp
• Optical Connection
  • Complies with 21 CFR 1040.10 and 1040.11
• Remote Control
  • RS232: EIA / TIA – 232; 57 600 Baud
  • USB: USB 2.0 – Device; 12 Mbit/s
  • LAN: IEEE – 802.3; 10/100 Mbit/s
• Power Supply
  • Type: Switch-mode, universal input
  • Main Voltage: 100-240 V; 50-60 Hz
  • Frequency: 50-60 Hz
  • Cooling: Passive, via surface and ventilation openings on both sides of the device